Dead Space 3 – Crafting Weapons Guide: Modules

Introduction:
These Modules are tools that can be attached to the lower Tool Slot of a frame. This can change the type of damage done or allow for things that are otherwise impossible or much more difficult.

Electrocution Module:
Electrocutes the last shot fired.
Location:

Explosive Module:
Causes the last shot fired to explode.
Location:

Rotator Cuff Module:
Allows primary tool to rotate 90 degrees.
Location: Conning Tower. Tungsten Torque Bar Room

Canister Recovery Module:
Allows recovery of last deployed canister.
Location: Onward: In the Pump Control Room on the entrance level of the Waystation.